[F] Resync MIDI Port 2 with Reset+Separate mode
Posted: 08 Jun 2023, 16:53
STATUS: Fixed in Firmware v1.1 - download it here: viewtopic.php?t=238
(original topic: viewtopic.php?t=228 )
Short description of the issue: When both Reset (rES setting set to On) and Separate (PLA setting set to SEP) modes are enabled, and that Port 2 is playing (Mute button lit) and Port 1 is not (Play button not lit), then pressing the Play button does not resync the devices connected to Port 2.
Setup: 2 sequencers connected each to a MIDI Port of the Midronome, let's call Sequencer 1 on Port 1 and Sequencer 2 on Port 2.
Steps to Reproduce: set rES setting to On and PLA setting to SEP, press the Mute button (Sequencer 2 starts), then press the Play button.
Expected Behavior: Sequencer 1 starts right away (because of Reset mode) and Sequencer 2 is resync'ed (restarted) so it is in sync with Sequencer 1.
Actual Behavior: Sequencer 1 starts right away, but Sequencer 2 is not resync'ed, so the two sequencers are out of sync with each other.
(original topic: viewtopic.php?t=228 )
Short description of the issue: When both Reset (rES setting set to On) and Separate (PLA setting set to SEP) modes are enabled, and that Port 2 is playing (Mute button lit) and Port 1 is not (Play button not lit), then pressing the Play button does not resync the devices connected to Port 2.
Setup: 2 sequencers connected each to a MIDI Port of the Midronome, let's call Sequencer 1 on Port 1 and Sequencer 2 on Port 2.
Steps to Reproduce: set rES setting to On and PLA setting to SEP, press the Mute button (Sequencer 2 starts), then press the Play button.
Expected Behavior: Sequencer 1 starts right away (because of Reset mode) and Sequencer 2 is resync'ed (restarted) so it is in sync with Sequencer 1.
Actual Behavior: Sequencer 1 starts right away, but Sequencer 2 is not resync'ed, so the two sequencers are out of sync with each other.