Midronome Community

I see the sync file generator can only output 44 and 48khz files. Will these work at 96khz or do I need to wait for an update? Thanks!

I think converting a file from 48 to 96 is done pretty well by DAWs, isn't it? I would guess they basically double each sample?
If that's the case then yea it should just work.
Have you tried?

Simon wrote: ↑07 May 2023, 19:52 I think converting a file from 48 to 96 is done pretty well by DAWs, isn't it? I would guess they basically double each sample?
If that's the case then yea it should just work.
Have you tried?

Thanks! I haven't tried yet. It's a bit of a small project to disconnect the USAMO and replace it with the Midronome, so I'm a little hesitant to do so since it can't sync the same way.

I did update the firmware, but that's as far as I've gotten so far.

Ha ha that's ok, take your time
Hopefully that update coming with the how-to videos will motivate you to take the step